Intended Use.

1) Prototype / development product

These Products are prototype/development electronic components intended for knowledgeable users (typical use: motion simulator builders). Unless explicitly stated in writing, Products are not certified to CSA/UL/CE/FCC/ISED or other safety/EMC standards.

2) Electrical limits — 12V DC and 24V DC only

• Products are intended for 12V DC and 24V DC systems only.
• Do not connect Products to mains voltage (120/240VAC) or any source outside the intended 12V DC or 24V DC system.
• Verify polarity and wiring before applying power.

3) Mandatory overcurrent protection (fire prevention)

All Products and any connected wiring must be protected by a 30A fuse (or lower where appropriate).

Using an oversized fuse, bypassing a fuse, or placing the fuse incorrectly can result in overheating, smoke, fire, or damage.

4) Enclosure and mounting requirement

Products must be installed securely inside a suitable enclosure that prevents accidental contact with energized conductors and reduces fire risk. Energy360 recommends a metal enclosure (properly bonded/grounded where applicable) or another enclosure with comparable heat resistance and mechanical protection.

Do not operate Products as exposed circuit boards in areas where they can be touched, shorted, contaminated, or mechanically stressed.

5) Wiring quality and connection heating risk

High-current 12V and 24V systems can generate significant heat at poor connections. Buyer is responsible for:

• using appropriate wire gauge and insulation,
• providing strain relief so terminals cannot loosen,
• properly tightening terminal connections,
• preventing chafing, pinching, or vibration loosening,
• ensuring adequate ventilation and spacing from flammable materials.

Loose terminal connections, undersized wires, or damaged insulation are common causes of overheating and fire.

6) Environmental and handling precautions

• Keep Products dry and away from conductive debris (metal shavings, carbon dust, etc.).
• Use ESD precautions when handling.
• Do not operate near fuels, solvents, or flammable vapors.
• Provide adequate clearance from heat-sensitive materials.

7) Buyer assumes responsibility; no support implied

Buyer is responsible for safe design, installation, integration, and operation of any system using the Products, including compliance with applicable laws, codes, and safety requirements. Any assembly or “how-to” documents are provided for convenience only and as-is, with no promise of support.

8) Prohibited / high-risk uses

Products must not be used in life-safety or safety-critical applications, including (but not limited to):

• medical or patient-connected systems,
• aviation or nuclear systems,
• automotive safety systems,
• any application where failure could reasonably be expected to cause injury or major property damage.

9) Incident reporting and traceability

If you experience any overheating event, smoke, fire, or near-miss involving Products, notify Energy360 promptly and include:

• a description of what happened,
• photos,
• your invoice/order number, and
• affected Product serial/batch ID (if available).